{"title":"3 3\/4'' (76.2 mm)","description":"\u003ch2\u003e3 3\/4 inch (76.2 mm) drill-center pulls (alternate listing)\u003c\/h2\u003e\u003cp\u003e3 3\/4 inch (76.2 mm) drill-center pulls appear under this listing as an alternate dimension or manufacturer-specific spec. Note that 76.2 mm is the standard metric equivalent of 3 inch, so a small number of products may use this label for what is physically a 3 inch pull. The catalog at this listing is narrower than the main 3 inch page. Most shoppers find their actual replacement match on one of the two canonical pages instead.\u003c\/p\u003e\u003ch3\u003eHow this size shows up\u003c\/h3\u003e\u003cp\u003eSome manufacturers cross-list dimensions where their internal catalog uses an unusual notation. This page collects pulls listed by their producer at 3 3\/4 inch with the 76.2 mm metric equivalent attached. Confirm the actual physical drill-center spacing against your existing holes before ordering, since this listing can include both 3 inch and 3 3\/4 inch products depending on the source brand's spec sheet. The cleanest check is to measure your existing hardware center-to-center with a steel rule before placing the order.\u003c\/p\u003e\u003ch3\u003eWhat to expect at this listing\u003c\/h3\u003e\u003cp\u003eA mixed set of small-to-medium drawer pulls in bar pull, cup pull, and decorative styles. Drawer fronts in the 12 to 18 inch range carry these sizes comfortably. Because the listing covers both interpretations, the safest practice is to measure the existing center-to-center spacing on the cabinet and pick the matching product from this page accordingly. The catalog skews toward bar pulls and decorative drawer pulls rather than cup pulls, which are uncommon at this listing.\u003c\/p\u003e\u003ch3\u003eAdjacent sizes worth comparing\u003c\/h3\u003e\u003cp\u003eThe standard 3 inch listing is \u003ca href=\"\/collections\/drill-centers-3-76-2-mm\"\u003e3 inch (76.2 mm)\u003c\/a\u003e. The standard 3 3\/4 inch listing is \u003ca href=\"\/collections\/drill-centers-3-3-4-95-2-mm\"\u003e3 3\/4 inch (95.2 mm)\u003c\/a\u003e. Check both pages if you're not certain which spec your existing hardware uses.\u003c\/p\u003e","products":[],"url":"https:\/\/knobs.co\/collections\/drill-centers-3-3-4-76-2-mm.oembed","provider":"The Knobs Company","version":"1.0","type":"link"}