6 1/4'' (158.8 mm)

A 6 1/4 inch pull has a center-to-center screw spacing of 158.8 mm. To confirm fit on an existing cabinet, measure from the center of one mounting hole to the center of the other using a ruler or calipers. If the cabinet was drilled to the European 160 mm standard, the 6 5/16 inch (160.3 mm) listing is the closer match, though the 1.5 mm difference is within tolerance for slotted mounting holes on most pulls.

The 158.8 mm center-to-center spacing is suited to drawer fronts roughly 24 to 32 inches wide. At that width, the pull spans enough of the face to provide balanced leverage and registers visually as a deliberate design element rather than an undersized accent. It also fits tall narrow doors such as pantry and broom-closet cabinets where vertical height, not width, drives the proportional choice.

The 6 inch (152.4 mm) size is 6.4 mm shorter center-to-center and is generally used on medium-width drawers below the wide-drawer threshold. The 6 1/2 inch (165.1 mm) size is 6.3 mm longer and fits drawers at the upper end of the wide-pull range. For replacement projects, the choice between these three sizes is settled by measuring the existing hole spacing precisely — the gaps are too small to bridge without redrilling if the cabinet was not pre-drilled to a compatible spec.

The 6 1/4 inch (158.8 mm) and the 6 5/16 inch (160.3 mm) European 160 mm equivalent differ by only 1.5 mm and are described in the catalog as functionally interchangeable in most installations. The dual listing reflects different manufacturer measurement conventions applied to the same physical drilling. In mixed metric-imperial cabinet construction — common in custom kitchens — either page may surface the same pull, so confirming the actual hole spacing on the cabinet before ordering is the reliable way to distinguish between them.