Hardware Resources UMS - 50/300 Clips Collection

Hardware Resources UMS 50/300 Clips undermount slide accessories

The Hardware Resources UMS 50/300 Clips Collection is a set of mounting clips for the brand's undermount drawer slide systems. This is an accessory family, not decorative hardware: the clips lock the front of an undermount slide to the underside of the drawer box and allow fine alignment.

What identifies the UMS 50/300 Clips look

These are small adjustable clips made to fit the USE-50, USE-100, and USE-300 undermount slide series. The line covers 2-way, 4-way, and 6-way adjustable clips, with the higher numbers giving more directions of fine-tune travel to square the drawer front. Options include a zinc base for heavy-duty service, a plastic base for standard use, and a narrow 2-way clip for drawers as small as 5 5/8 inches wide. The clips disappear under the drawer once installed, so the value is alignment and hold, not appearance.

Buying considerations

This line is for cabinet builders and remodelers installing or servicing Hardware Resources undermount slides. Match the clip to the exact slide series in the cabinet, since clips are series-specific and the wrong one will not seat. Choose the 6-way clip when the drawer needs the most adjustment to align gaps evenly across a run; the 2-way is enough for simple boxes. Use the zinc-base clips for heavy or frequently used drawers and the narrow clip for very small drawers where a standard clip will not fit. Confirm the drawer width and slide model before ordering. The 6-way clip is worth the small added cost on a face-frame run where gaps need to line up evenly across many drawers. Keeping a few spare clips on a large job saves a trip when a box runs out of square. Getting the clip choice right is what lets the installer dial in even reveals rather than living with a drawer that sits slightly off.

Related Hardware Resources collections

Browse the full Hardware Resources brand page for compatible undermount slide systems.