Window Hardware - Tilt & Turn

Tilt and turn window hardware: dressing up the operator handle

One handle does two jobs on a tilt-turn window: point it one way and the sash swings open like a door, point it the other and the top tilts inward for ventilation. Everything here is the decorative trim around that handle, not the tilt-turn mechanism itself, which a European-style window maker builds into the sash long before it reaches installation. The Ellis Tilt & Turn Trim runs 1 1/2" x 4 1/2", and the Stepped Trim (EW308) covers roughly the same footprint in a different profile, with a step where the plate meets the handle base instead of tapering smoothly into it.

Arched trim needs an arched opening

The Arched Tilt & Turn Trim comes in three widths: EW705 at 1 1/2" x 3", EW708 at 1 1/2" x 4 1/2", and EW707 at 1 3/8" x 4 1/2", so a plate can follow the actual radius of the window head instead of getting forced onto it. The Curved Trim, in EW501 and EW508, softens the profile without a true arch. The Corbel Arched (EW30600) and Corbel Rectangular (EW30700) trims add a decorative shoulder detail that the plain arched and rectangular pieces skip entirely, noticeable mainly at close range rather than across a room.

Sizing against hardware that's already there

This trim mounts over an existing operator, so screw spacing and backset need to match what the window already has cut for it, not the reverse. Every piece here stays compact, mostly between 1 1/2" and 4 1/2" long, since tilt-turn hardware runs smaller by nature than a complete entry-door handle set. Pull the window manufacturer's hardware sheet, or measure whatever trim is being swapped out, rather than guessing off the window's overall size or its frame material, both of which vary by manufacturer.